How to repair the automatic labeling machine when it is broken? -Automatic labeling machine manufacturers-Online printing labeling machine-Shenzhen Bogao logo
by:Zhongya Packaging
2022-02-08
In modern industry, many enterprises use automatic labeling machines. Once this product equipment is broken, how to repair it has become one thing most people want to know. The automatic labeling machine is broken. , How to do a good job of maintenance, in fact, everyone here hopes to be able to understand all aspects through a variety of different methods. (1) Adjustment of the pressure brush device. When performing actual maintenance on the automatic labeling machine, various adjustments should be made in accordance with the actual situation. When the entire toothbrush center is actually adjusted, more symmetry must be considered, and all The pressure brush must be vertical to the surface. In this case, then consider more vertical conditions, and the adjustment of the entire indenter must be done well. (2) Label box adjustment When the automatic labeling machine is actually adjusted, it must be adjusted effectively according to the specific situation. At present, if adjustment is to be made, all the gaps are basically controlled within 0.8 mm to one. If the gap is too large, it will cause the entire displacement. When there is a gap, the gap is too small and will cause all the bidding to be unsmooth. In the entire standard and the actual adjustment, the up, down, left, and right will also be considered basically For the grappling hook, more adjustments must be considered on the same vertical plane, so the roller adjustment of the label must be done well, and the pressure plate of the label must be equipped with various adjustment lines when adjusting. (3) When the automatic labeling machine adjusts the labeling station during actual labeling, if there is a gap, it can be adjusted by adjusting the eccentric bolt, and any contact pressure must be taken into account when adjusting, so as to ensure There is no pressure. If the gap is too large, there must be too much glue on the label, which will cause throwing. If the gap is too small, the contact will be tight and all the glue will be squeezed away. Practice has proved that the gap between the target plate and the hose is usually controlled between 0.1 mm and 0.2 mm.
Custom message