Why is the labeling position of the automatic labeling machine not exactly the reason? -Automatic labeling machine manufacturers-Online printing labeling machine-Shenzhen Bogao logo

In our daily life, we can always see certain products marked with labels, such as food, meat, or vegetables, or your favorite snacks, tissues, or cups, feminine products, and male skin care products. These are all marked with labels. The purpose of this is to make the customers see more clearly, and to avoid the situation that there is no label during the purchase process and the wrong purchase. The production of trademarks can also be applied to the clothing industry, yardage, fabrics , Production area, etc., can be seen clearly, but also to satisfy consumers! So why is the labeling position of the automatic labeling machine not exactly the reason? 1. The pressure belt installation may not be tight, causing the standard belt to loosen and the electric eye detection is inaccurate. Tighten the label processing. 2. The traction mechanism may slip or not be pressed tightly, and the bottom paper may not be taken away smoothly. Tighten the traction mechanism to handle it. If it is too tight, the label will be distorted. It is better to pull the bottom paper normally. (Usually if the bottom paper is pulled out when it is wrinkled, it should be pressed too tightly) 3. The shape of the object to be pasted is not uniform or the positioning is not uniform. Control the quality of production. 4. The object to be labeled should be placed parallel to the direction of labeling (pay attention to whether the product can move during the labeling process, and the left support rod can be appropriately advanced a little bit more than the right). 5. At the labeling station, the object to be attached should rotate smoothly (be careful not to touch the stripping board). When the object is too light, the covering rod should be lowered to press the object to be attached. 6. In the double-label state, the labeling machine outputs a single label (1) After a single label is output, the workpiece continues to rotate because there is no delay for the second label, and the machine is waiting for the second label labeling signal status. (2) After a single label is issued, the workpiece stops. It is because there is signal interference in the measuring sensor (reset the sensor) or the delay control is abnormal (after clicking on the jog 2 twice, then clicking on the jog 1 twice again.