What methods need to be mastered during the operation and debugging of the automatic labeling machine equipment? -Automatic labeling machine manufacturers-Online printing labeling machine-Shenzhen

The automatic labeling machine equipment has the function of automatic labeling and has a wide range of applications. It is an indispensable part of modern packaging. However, the debugging process of the labeling machine equipment is also a focus of the big guys. The labeling machine equipment needs to be operated in accordance with the process. . Failure to follow the correct operation method of the labeling machine equipment debugging process may affect its labeling rate. So what methods do you need to master during the operation and debugging of the fully automatic labeling machine equipment? 1. Loosen the fixing screws Adjust the screws on the roll paper tray. First remove the plexiglass tray, and then adjust the rear tray area so that the rear tray area can meet the position of the paper tray and ensure that it is on the center line of the paper tape. Tighten the screws, install the paper tray and the plexiglass front tray, then fix the screws and turn the roll paper tray after fixing it to check whether its flexibility is good. If you find that the paper tray is not flexible, you can also do it Adjust accordingly to make it more flexible. 2. Labeling paper tape Before we put on the labeling paper tape, we should check the equipment rollers of the labeling paper tape to check whether all the rollers are flexible enough. If there are insufficiently flexible rollers, we must You can continue to operate only after you adjust it to be flexible. In addition, the threading method of the automatic labeling machine should also pay special attention to allowing the sticker to pass through the sensor for effective operation to ensure the normal operation of the equipment. 3. Trial paste operation After adjusting the equipment, we need to carry out trial paste debugging. You can first place the bottle on the conveyor belt, and then adjust the bottle bar, and then adjust the distance and other steps, you can press the motor switch. Master the correct debugging process of the automatic labeling machine equipment, so that the labeling machine equipment can better meet the full-circle labeling or half-circle labeling of round bottles. The labeling switch between bottles is simple and the adjustment is convenient. The above is the relevant answers of our Bogao logo for the debugging of the automatic labeling machine. If you have a labeling machine need, please contact us, our staff will give you the most considerate service, and our Bogao logo welcomes you.