Summarize the nine common failure phenomena of labeling machines-automatic labeling machine manufacturers-online printing labeling machine-shenzhen bogao logo

Under normal circumstances, mechanical products will have some wear and tear after a certain number of years of use, and have a certain life. The length of the life depends on whether the user knows how to use and maintain the equipment. Therefore, it is very important to understand the failure knowledge of some commonly used labeling machines. It is necessary, the following are some solutions to 9 common faults, I hope to open up everyone's ideas to solve the problem. 1. Remaining label paper on the target plate. Adjust the position of the clamp finger. The glue transition is too large. Adjust the glue temperature. The left side of the mark plate will take less glue, which will cause the mark paper to lift up. Adjust the position of the mark plate. 2. The labeling paper is skewed. According to the position of the label paper on the target plate, adjust the height of the label box on the left and right. 3. The labeling paper is wrinkled and uneven. Adjust the thickness of the rubber film on the rubber roller. 4. Curled corners and flashes of labeling paper. The glue is not evenly taken from the target plate. Adjust the position of the target plate to make it evenly take the glue. 5. The machine stops suddenly while it is running. Whether there is a bomb bottle to explode the protective door, just close the protective door, whether there is no wine in the front chain path or the back chain is blocked, if there is a bottle of wine in the labeling machine, take it out. 6. Throw the bottle during operation when applying the top label. Check whether the high and low position of the bottle pressing head is appropriate, adjust its position, check whether the ball in the bottle pressing head is missing, which causes the bottle to rotate inflexibly, just replace it, check if the backing plate behind the bottle at the label delivery position of the rotating hub is in place, and adjust it. . 7. The mark paper is damaged or improperly topped behind the top mark indenter. Replace the sponge pad and rubber spring pad in the indenter device. 8. Poor cosmetic effect. Check the belt position, adjust it to a suitable position, and clean up if the cosmetic spray nozzle is blocked. 9. The coding is not clear and the position is not centered. Check whether there are foreign objects or water droplets on the bottle cap, adjust the position of the blowing pipe, check whether the nozzle is clean, flush the nozzle, adjust the position of the nozzle, and make the spray code centered. The above 9 common phenomena are summarized by the labeling machine manufacturer’s engineers after years of Ru0026D and production experience. I hope to help everyone. In order to make the labeling machine use longer, if the parts of the machine are severely worn , Must be replaced in time.