Introduction of abnormal adjustment method of automatic labeling machine-automatic labeling machine manufacturer-online printing labeling machine-shenzhen bogao logo

The use of machinery will inevitably cause problems, so we must pay special attention to it during use, especially when using the labeling machine. Under normal circumstances, labeling equipment has a fault alarm function. For example, a fully automatic labeling machine has functions such as fault alarm function, production counting function, power saving function, production number setting prompt function, parameter setting protection, etc. Complete fault self-check, but not all labeling equipment is equipped with an intelligent control system. The manufacturer of the Bogao logo labeling machine tells you that this is the first point to be clear, let us continue to look down: The labeling machine misses the label, usually due to these two situations: the sensitivity of the sensor is not good, just adjust the appropriate sensitivity of the sensor; If the labeling speed is too slow or the conveyor belt speed is too fast, the speed needs to be adjusted. Besides, there are other common problems. No label. The first thing to check is whether the system is faulty and the cause of the fault. Secondly, check the electric eye of the measured object: if the position is wrong, you need to adjust the position of the electric eye; if the electric eye is defective, you need to replace the electric eye. If the labeling head is not tight enough to pull the paper, it will cause the label to fail. Just adjust the pulling paper; maybe the power of the labeling head is not connected, just turn on the power. The bids are successively issued. Check the label electric eye: the label electric eye position is wrong, adjust the position of the electric eye; if the label electric eye is defective, adjust or replace the label electric eye. Cannot be labeled. There are mainly six situations: the marking speed is too slow, and the marking speed is increased; the reserved label is not long enough, and the length of the reserved label is increased; the marking speed is too fast, and the marking speed is reduced; Too far; the interval is too small, increase the speed of the entrainment belt; the label has poor adhesion or the object is not clean. Wrinkles after label application. This problem directly affects the labeling function and quality, and needs to be carefully removed. Generally, there are two situations: the reserved label is too long, and the reserved length of the label needs to be reduced; the speed of the label delivery is too fast and the speed of the clamping belt is relatively slow, and the speed of the two needs to be adjusted to match. The above is a brief introduction of the automatic labeling machine editor on the abnormal adjustment method of the automatic labeling machine. For details, please consult this site.