Correctly maintain the automatic labeling machine method-automatic labeling machine manufacturer-online printing labeling machine-shenzhen bogao logo

Maintenance can keep the performance of the automatic labeling machine in the best condition, and can also greatly increase the service life, so the maintenance method must be correct. This time, the correct automatic labeling machine maintenance method is introduced. . 1. The gear meshing point, the oil injection hole of the bearing with a seat, and the moving parts should be regularly lubricated. Once every shift, it is strictly forbidden to run the reducer without oil. When filling lubricating oil, be careful not to put the oil tank on the rotating belt, so as to avoid the belt slipping, throwing or premature aging and damage. In the absence of oil, do not let the reducer run, and after the first 300 hours of operation, replace the internal oil with new oil, and replace the lubricating oil every 2500 hours. Do not drop oil on the belt during lubrication, as this will cause the automatic labeling machine to slip or wear prematurely. 2. The metering parts must be cleaned in time after shutdown. It is necessary to clean the heat-sealed body frequently, especially some packaging materials with high sugar content, clean the turntable and the feed door, and also need the heat-sealed body. The parts that are frequently cleaned are to ensure that the sealing line of the finished product is clear, and the scattered materials should be cleaned in time to facilitate the cleaning of the parts, so as to better extend the service life and clean the internal dust. The electric control box is often used. If an electrical failure occurs, such as a short circuit or poor contact. 3. The screws of each part of the automatic labeling machine must be checked regularly, and they must not be loosened. Otherwise it will affect the normal rotation of the entire machine. The electrical part of the machine should be waterproof, moisture-proof, anti-corrosion, and rat-proof to ensure the inside and connection of the electrical control box. The terminals are clean to prevent electrical failure. After shutting down, the two heat sealers should be in the open position to prevent burns from the labeling packaging materials.