What should I do if there is accumulation of labeling on the labeling machine-industry news

1. There are two main reasons for this phenomenon, the first is the problem of the conveyor belt, and the second is the problem of the bottle divider.　　　　2. The chains and gears on the conveyor belt lack lubricating oil, which causes the conveyor belt to be unstable during operation. If one of the cards gets stuck, the bottles will pile up on each other, 　　　　 In this case, just apply some lubricating oil to the chain and gear parts of the conveyor belt.　　　　 3. After a long time of use, the conveyor belt will slowly produce some cracks. If the normal inspection is not good, the cracks become larger in use, and the product on the conveyor belt will accumulate, and a new conveyor belt needs to be replaced.　　　　 4. There are foreign objects on the conveyor belt or gears, which may make the conveyor belt run poorly and cause product accumulation.　　　　 5. If it is not the problem of the conveyor belt, it is probably the problem of the bottle divider. This situation is more impetuous and requires debugging. This article briefly introduces the debugging method of the bottle divider. (1) Open the front f side plate of the bottle separator, see the transmission part of the separator, and then use a fork wrench to loosen the four bolts on the timing belt. Note: Due to different models, the position of the bolts will not be subtle The difference is basically between the small chain and the large chain. Make sure that the bolts are loosened, and then start to adjust the position of the bottle divider. Finally, adjust the bottle divider to the position synchronized with the bottle feeding star wheel. After adjustment, install everything Remove the bolts of the bag. Start to detect whether there is accumulation, carefully check the problem, and then open the bottle divider to adjust.　　　　 (2) After adjusting the bottle divider, it is required that the opening of the bottle divider and the bottle inlet star wheel should be aligned to ensure that the bottle shape will not be squeezed or blocked when the product enters the star wheel.　　　　2 The bottle is placed between the bottle divider and the star wheel device of the bottle stopper. The bottle is close to the side of the bottle separator or the stop star wheel device, and the gap on the other side of the bottle body is about 3-5mm.