The adjustment methods of each part of the labeling machine diary are summarized-industry news

We all know that high-efficiency automation equipment has become an indispensable part of the manufacturing industry. Continuous 24-hour work has become the norm, but whenever a new product enters the production line, mechanical engineers will spend a lot of time debugging the equipment as a label. The following equipment debugging methods of the machine manufacturer. I hope it helps you. 　　　　 1. Pressure brush device adjustment 　　　　Disposal method 　　　　 The center of the brush is aligned with the label and the two sides are symmetrical and perpendicular to the surface of the container. The cross overlap gap of the brush press is 10-15 mm for a single press brush, and 5 mm-10 mm for a combined press brush. The distance between the cleaning brush and the sponge is between 1 mm and 2 mm. When there is no bottle, the pressing head should be lower than 20 mm when there is a bottle.　　　　 2. Adjust the label box 　　　　Disposal method 　　　　 The center line of the label carton, the center axis of the label station and the label paper are tangent, and the three-point connection with the center axis of the standard board. Adjust the tangent (contact) between the label and the label paper, and then move the label box closer to 1 mm~2 mm. The gap between the label box and the pressure strips on both sides is 0.8-1mm. If the label gap is too large, it will easily cause the label paper to move in the label box, resulting in oblique marking; if the label gap is too small, the label paper will not be smooth. Adjustment of the label supply roller: When there is no label, the label pressing plate can be pressed to the front end of the label box, and the label (label) cannot be crushed when the label is attached. Adjustment of the position of the label-grabbing hooks of the standard box: the upper and lower hooks can evenly grab the label paper on the same vertical plane.　　　　3. Enter/leave the bottle star wheel, adjust the bottle feed screw 　　　　Disposal method 　　　　 bottle feed star wheel adjustment: When the press bottle is just pressed into the bottle, adjust the bottle feed star wheel so that the bottle is in the center of the groove.　　　　 Adjust the bottle star wheel: When the press bottle is just raised, adjust the star wheel so that the bottle is located in the center of the groove of the star wheel.　　　　 bottle feeding screw adjustment: take the bottle feeding star wheel as the standard, when the bottle feeding star wheel groove is in the middle, adjust the screw rod so that the screw rod enters the bottle side and abuts against the bottle without displacement.　　　　4. Site adjustment 　　　　Disposal method 　　　　Adjustment of the squeegee and the rubber roller: There is no gap between the squeegee and the rubber roller in the entire length. If there is a gap, it can be adjusted by adjusting the eccentric bolt.　　　　 gluing and adjustment of the target plate: the target plate and the rubber roller contact without any pressure. Too big a gap, too much glue on the target plate, resulting in glue rejection; because the gap is too small and the contact is too tight, the glue will be squeezed out, and the half side of the target plate will not stick. The results show that the best gap between the standard plate and the rubber roller is between 0.1 mm and 0.2 mm. The bearing seat at the lower end of the rubber roller can be adjusted, and the upper bearing of the rubber roller can be adjusted if necessary. The 　　　　 labeling machine has become the norm after daily handling of various matters. I want to do things more efficiently and can’t stand still, so we still write it down and discuss it with our friends.